(4)Ball And Socket Joints
Lubricate joints on each end of lift links and center shift link. Total 6 fittings (49G1-49G811).
(5)Blade Lift Shafts
Lubricate rear bearings on blade lift shafts. Total 2 fittings.
(6)Circle Reverse Shaft Bearing
Lubricate bearing at rear of shaft. 1 fitting.
(7)Blade Lift Input Shaft Support Bearings
Lubricate shaft bearings under frame, ahead of center shift rack. Total 2 fittings.
(8)Center Shift Pinion And Rail
Lubricate pinion at bottom of shaft. Lubricate rail at rear. Total 3 fittings.
(9)Circle Guide Shoes
Lubricate on bottom side. Total 6 fittings.
(10)Circle Draft Ball Joint
Lubricate 1 fitting on each side of cap. Total 2 fittings. (49G1-49G811).
(11)Axle Pivot Pin Bearings
Lubricate at center of axle, ahead of center tie rod ends. 1 fitting.
(12)Steering Gear Shaft - Steering Arm Block
Lubricate shaft in front of block. Lubricate block at top and rear. Total 4 fittings.
(13)Tie Rod End (Inner)
Lubricate at side and rear of forks. Total 4 fittings.
(14)Tie Rod Fork, Block And Wheel Lean Bar
Lubricate fork on top side, and block at rear of spindle, at both wheels. Total 4 fittings.
Lubricate left wheel lean bar and arm pivot pin at front. Total 2 fittings.
(15)Lean Arm And Cylinder Pivot Pins
Lubricate right wheel lean arm at front. 1 fitting.
Lubricate wheel lean cylinder pivots on end of cylinder and rod. Total 3 fittings.
(16)Axle Pivot Pin
Lubricate at center of axle, at front. 1 fitting.
(17)Wheel Lean Bar And Arm Pivot Pin
Lubricate right wheel lean bar at front. 1 fitting.
(18)Steering Cylinder Support
Lubricate at top and bottom. Total 2 fittings.
(19)Blade Tip Pivots
Lubricate pivots at rear of blade on both sides. Total 2 fittings.
(20)Blade Tip Cylinder Support Bearings
Lubricate each cylinder at top and rod end. Total 4 fittings.
(21)Power Blade Cylinder Rod
Lubricate at end of cylinder rod. 1 fitting.
(22)Transfer Gear Drive Shaft
Lubricate telescopic shaft at lower end. 1 fitting.
(23)Ripper-Scarifier Trunnion Block Bearings
Lubricate bearings on both sides of each block. Total 4 fittings.
(24)Ripper-Scarifier Linkage Pins
Lubricate 4 fittings on each side.
(25)Top Of Circle
Apply grease with paddle.