(4)Drive Pinion, Blade Lift And Blade Lift Shaft And Link Ball Sockets
Lubricate 5 fittings on each side. Total 10 fittings.
(5)Center Shift Pinion Drive Housing And Link Ball Sockets
Lubricate 3 fittings.
(6)Circle, Shoes And Spacers
Apply lubricant with a paddle to top and bottom of circle, front and back of 4 guide shoes and ends of circle teeth.
(7)Power Control Output Shaft
Lubricate 1 fitting.
(8)Scarifier
- 1. Lubricate 1 drive housing fitting.
- 2. Lubricate 4 link ball sockets and 1 drive shaft fittings.
(9)Steering Gear Shafts
- 1. Lubricate 3 fittings.
- 2. Lubricate 1 fitting (recessed in bolster housing).
(10)Steering Cylinder, Draft Ball Joint And Tie Rod Block
Lubricate 8 fittings.
(11)Tie Rod Ends, Front Wheel Rack And Worm Gear Housing
Lubricate 4 fittings.
(12)Tie Rod And Steering Arm
Lubricate 3 fittings at each front wheel. Total 6 fittings.
(13)Lean Pivot And Knuckle Pins
Lubricate knuckle pins top and bottom, at each front wheel. Total 4 fittings.
(14)Wheel Rack And Axle Pivot Pin
Lubricate front wheel rack and axle pivot pin at front. Total 3 fittings.
(15)Front Wheel Lean Pivot Pins
Lubricate 3 fittings at each front wheel. Total 6 fittings.
(16)Bevel Pinion And Wheel Lean Housing And Shaft
Lubricate 5 fittings.
(17)Wheel Lean And Scarifier Shafts Support Bearings
Lubricate 2 fittings.