Every 10 Service Hours Or Daily
`
16G MOTOR GRADER
[GEG05080]
16G MOTOR GRADER
Fuel And Lubricant Specifications
16G MOTOR GRADER
Every 50 Service Hours Or Weekly
MACHINE ARRANGEMENT
1.1. (1)Radiator
2.1. (2)Precleaner Screen
3.1. (3)Engine Crankcase
4.1. (4)Air Reservoir
(1)Radiator
Show/hide table
![]() |
Always inspect cooling system with engine stopped. Remove radiator cap slowly to relieve pressure. Steam can cause personal injury. Inhibitor contains alkali, avoid contact with skin and eyes to prevent personal injury. |
![]() |
Measure coolant level with engine stopped and cold.
- 1. Remove radiator cap slowly to relieve pressure. Inspect cap gasket, replace if necessary.
- 2. Coolant level is satisfactory if within 1 to 1-1/2inches (2.5 to 3.8 cm) below top of fill pipe.
NOTE: If it is necessary to add make-up water daily, check for leaks.
(2)Precleaner Screen
- 1. Inspect precleaner screen for accumulation of dirt or debris.
(3)Engine Crankcase
- 1. Measure oil level.
- 2. Engine Stopped: Maintain oil level between ADD and FULL marks on STOPPED side of dipstick.
- 3. Engine Running: Maintain oil level between ADD and FULL marks on RUNNING side of dipstick.
(4)Air Reservoir
Drain moisture and sediment from both sections of the air reservoir.
Information System:
16G MOTOR GRADER
Fuel And Lubricant Specifications
16G MOTOR GRADER
Maintenance Recommendations
16G MOTOR GRADER
Safety
NO. 140 MOTOR GRADER
When Required
NO. 140 MOTOR GRADER
Every 2000 Service Hours Or 1 Year
NO. 140 MOTOR GRADER
Every 1000 Service Hours Or 6 Months
NO. 140 MOTOR GRADER
Every 500 Service Hours Or 3 Months
NO. 140 MOTOR GRADER
Every 250 Service Hours Or Monthly
NO. 140 MOTOR GRADER
Every 50 Service Hours Or Weekly
NO. 140 MOTOR GRADER
Fuel And Lubricant Specifications
NO. 140 MOTOR GRADER
Safety
NO. 120 MOTOR GRADER
When Required
16G MOTOR GRADER
Every 50 Service Hours Or Weekly
16G MOTOR GRADER
Every 250 Service Hours Or Monthly
16G MOTOR GRADER
Every 500 Service Hours Or 3 Months
16G MOTOR GRADER
Every 2000 Service Hours Or 1 Year
16G MOTOR GRADER
When Required
Analyzing Cylinder Condition By Measuring Air Flow{0651, 1000}
PSP FOR TANK REWORK TO ELIMINATE SEAL FAILURES BETWEEN IMPLEMENT VALVE AND TANK - COSA LETTER NO. 7 - PS0803 - MAILED COS A - REVISED 03/96
ASPHALT SCREEDS, HYDRAULIC SYSTEM, FUEL BURNER SYSTEM & ELEC
Schematic
ASPHALT SCREEDS
VIP Screed
ASPHALT SCREEDS
Systems Operation
ASPHALT SCREEDS
Testing and Adjusting
PAVEMASTER ASPHALT SCREEDS
Main Screed