INCORRECT WHEEL SAW BIT HOLDER RELEASED AS SERVICE REPAIR PART Caterpillar


`
INCORRECT WHEEL SAW BIT HOLDER RELEASED AS SERVICE REPAIR PART [TIBU3914]
WORK TOOLS
GROUND ENGAGING TOOLS (G.E.T.)
INCORRECT WHEEL SAW BIT HOLDER RELEASED AS SERVICE REPAIR PART

CONFIDENTIAL TIBU3914-00

TECHNICAL INFORMATION BULLETIN

JULY 23, 2003

WORK TOOL

SKID STEER LOADER

MULTI TERRAIN LOADER

SW54 (WWS1-UP),

SW60 (WLS1-UP) WHEEL SAW

228 (6BZ1-UP),

248 (6LZ1-UP) SKID STEER LOADERS

 

Component Code(s): 6712, 0751, 7000

SUBJECT: INCORRECT WHEEL SAW BIT HOLDER RELEASED AS SERVICE REPAIR PART

PROBLEM:

The 226-9308 Bit Holder was released as the service repair part for the SW45 and SW60 Wheel Saws. This is incorrect. The 226-9308 Bit Holder should not be used on SW45 and SW60 Wheel Saws.

SOLUTION:

A new service replacement part is now pending release. The new 242-6968 Bit Holder is expected to be available in the parts system by mid-September.

In the meantime, contact one of the following individuals if you have problems and require new bit holders for your SW45 and SW60 Wheel Saws:

Kent Pellegrini

NACD Ind & Work Tool

S. Henry Long

CWTS-BCP Product Support

Telephone: 309 675-6158

Telephone: +44(0)1455 825712

Email: [email protected]

Email: [email protected]

 

COPYRIGHT 2003 AVSpare
ALL RIGHTS RESERVED

Information System:

A new procedure for the pressure limiter valve test and adjust.
BAD GROUND CONNECTIONS MAY CAUSE ENGINE PROBLEMS
POSSIBLE CRACKING OF SALT (Sealed And Lubricated Track) LINK ASSEMBLY TRACK PINS
Installing the New 233-9579 Suction Hose May Cause Cracking of the Output Transfer Gear Case
5K-8591 Bearing Failures May be Due to a Defective Shaft
Shock Hazard for the VR-6 and K65-12B Voltage Regulators
EXPANSION/SPLITTING OF THE STICK AS A RESULT OF WATER ENTERING THE STICK AND FREEZING DURING EXTREME COLD WEATHER CONDITIONS
MODIFICATIONS ARE NECESSARY IN ORDER TO USE THE 165-9889 BROOM BRACKET GP ON ALPHA XR MACHINES
Air Filter Restricted Indictor May Illuminate at Low Hours or with Clean Filters
INTERFERENCE BETWEEN THE LIFT ARMS & CERTAIN WORK TOOLS
SOS PARTICLE COUNT LIMITS FOR THE FAIRFIELD DRIVE IS HIGHER THAN THE LIMITS FOR OTHER CATERPILLAR MACHINES
Loose Counter Weights Can Cause Banging Noise When Turning
Liner Flange Breakage
Caterpillar Monitoring System Module May Experience Cat Data Link Communications Problems
A LEVEL SWITCH (HYDRAULIC OIL) CAN BE ADDED TO THE HYDRAULIC TANK
Adapter Welds And Base Edge Cracking
180-0041 BRUSH KIT MAY SHORT
Modification to Prevent Air Leaks at the Primary Fuel Filter
PROTECTIVE LENSES ON THE FRONT WORKING LIGHTS
Incorrect Pressure and Flow Compensator Valve for the Piston Pump (Steering) Is Shown in the Parts Book
Information that is required to understanding and the determining of the root cause of a piston pin joint failure
Replace Failed 3054E and 3056E Fuel Injection Pumps with New Pumps from Cat Parts
THE RETAINING RING FOR THE TRANSMISSION CLUTCH MAY COME OUT OF THE GROOVE
The Rubber Stopper On The Oil Level Gauge For The Swing Drive May Come Loose