![]() | |
Illustration 1 | g00915325 |
Note: All bores must be free of paint. Coat all bores for pins with 5P-0960 Molybdenum Grease .
Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward.
(1) Two 7Y-2397 Sleeve Bearings
- Outside diameter ... 116.230 ± .013 mm (4.5760 ± .0005 inch)
- Inside diameter ... 100.29 mm (3.948 inch)
- Bearing depth in the bearing bore ... 9.5 ± 0.8 mm (.37 ± .031 inch)
- Inside diameter ... 100.29 mm (3.948 inch)
(2) The 9X-4597 Lip Seal must be lightly lubricated with 5P-0960 Molybdenum Grease prior to assembly.
(3) 212-8078 Pin Assembly
- Diameter of the pin ... 79.9 mm (3.14 inch)
- Bore diameter for the pin ... 80.0 mm (3.15 inch)
(4) Use the necessary shims to adjust the lateral clearance to a maximum of 1.6 mm (.063 inch).
- 093-0083 Shim ... 1.0 mm (.039 inch)
- 7Y-2498 Shim ... 1.6 mm (.063 inch)
- 093-0115 Shim ... 2.0 mm (.079 inch)
- 7Y-2498 Shim ... 1.6 mm (.063 inch)
(5) 212-8078 Pin Assembly
- Diameter of the pin ... 79.9 mm (3.14 inch)
- Bore diameter for the pin ... 80.0 mm (3.15 inch)
(6) Use the necessary shims to adjust the lateral clearance to a maximum of 1.6 mm (.063 inch).
- 093-0083 Shim ... 1.0 mm (.039 inch)
- 7Y-2498 Shim ... 1.6 mm (.063 inch)
- 093-0115 Shim ... 2.0 mm (.079 inch)
- 7Y-2498 Shim ... 1.6 mm (.063 inch)
(7) Two 7Y-2395 Sleeve Bearings
- Outside diameter ... 85.160 ± 0.013 mm (3.3527 ± .0005 inch)
- Inside diameter ... 70.23 ± 0.02 mm (2.7650 ± .0008 inch)
- Bearing depth in the bearing bore ... 7.5 ± 0.8 mm (.30 ± .03 inch)
- Inside diameter ... 70.23 ± 0.02 mm (2.7650 ± .0008 inch)
(8) The 093-1434 Lip Seal must be lightly lubricated with 5P-0960 Molybdenum Grease prior to assembly.
(9) Two 7Y-3427 Sleeve Bearings
- Outside diameter ... 95.180 ± 0.013 mm (3.7472 ± .0005 inch)
- Inside diameter ... 80.25 ± 0.02 mm (3.159 ± .001 inch)
- Bearing depth in the bearing bore ... 7.5 ± 0.8 mm (0.30 ± .03 inch)
- Inside diameter ... 80.25 ± 0.02 mm (3.159 ± .001 inch)
(10) 096-0854 Seal must be lightly lubricated with 5P-0960 Molybdenum Grease prior to assembly.