NOTICE |
---|
Replace circuit breakers with the same type and size only. Otherwise, electrical damage can result. If it is necessary to reset circuit breakers frequently, an electrical problem may exist. Contact your AVSpare dealer. |
![]() | Circuit Breakers - Push in the button to reset the circuit breaker. If the electrical system is working properly, the button will remain depressed. If the button does not remain depressed, check the appropriate electrical circuit. Repair the electrical circuit, if necessary. |
![]() | |
Illustration 1 | g01032239 |
Location of the circuit breaker panel |
![]() | |
Illustration 2 | g01012253 |
(1) 15 Amp - AVSpare Monitoring System, gauge lamps.
(2) 15 Amp - Remote control system (if equipped).
(3) 15 Amp - Spare.
(4) 15 Amp - Lift arm positioner, Payload Control System (PCS) (if equipped), auto lubrication indicator.
(5) 15 Amp - Engine ECM, service tool diagnostic connector, ET service connector.
![]() | |
Illustration 3 | g01012260 |
(6) 30 Amp - Air conditioning system (if equipped).
(7) 15 Amp - Automatic lubrication system (if equipped), horn.
(8) 15 Amp - Residual brake pressure indicator (if equipped), stop light (if equipped), wipers/washers (if equipped), backup alarm, cassette player (if equipped), dash lamps.
(9) 15 Amp - Power Train Electronic Control Module.
(10) 15 Amp - Parking brake control.
(11) 15 Amp - Key start switch, ECM, idle timer/fire suppression control (engine shutdown) (if equipped).
(12) 15 Amp - Cassette player (if equipped), dome lamp (if equipped).
(13) 30 Amp (Automatic) - Right side lights, cab rear floodlight.
(14) 30 Amp (Automatic) - Left side lights, tail light (if equipped), cab lower floodlight.
![]() | |
Illustration 4 | g01012266 |
(15) 80 Amp - Main.
(16) 80 Amp - Alternator.
The circuit breaker prevents circuit overload. Each circuit breaker has a specified current rating, depending on the system requirements. If an overload occurs on a system, the circuit breaker element will separate, power will not be supplied to the system until the circuit breaker has been reset. If the circuit breaker element separates again a fault is present in the related electrical system.