AP655D and BG655D Asphalt Pavers Machine Systems Steering Column - Assemble Caterpillar

Assembly Procedure

Show/hide table

Illustration 1	g01401485

1. Install O-ring seal (18) on position sensor (1).
   Show/hide table

   Illustration 2	g01401484

2. Install mounting block assembly (17) to plate (15) and install bolts (16).
   Show/hide table

   Illustration 3	g01401483

3. Install shaft (14) and roll pin (13).
   Show/hide table

   Illustration 4	g01401482

4. Install spacer (9), spring (10), and snap ring (11).

5. Install woodruff key (12).
   Show/hide table

   Illustration 5	g01401481

   Show/hide table

   Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force.

6. Install torque arm (7) and tighten set screws (8).
   Show/hide table

   Illustration 6	g01401480

7. Install roll pin (6).
   Show/hide table

   Illustration 7	g01401479

8. Install plate (5), tubes (3), and bolts (3).
   Show/hide table

   Illustration 8	g01401478

9. Apply Tooling (A) to bolts (2). Install position sensor (1) and bolts (2). Tighten bolts (2) to a torque of 1.0 ± .25 N·m (9 ± 2 lb in).

End By:

1. Install the steering column. Refer to Disassembly and Assembly, "Steering Column - Install".