| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 6V-9830 | Cap As | 1 |
| 9V-9828 | Cap As | 1 | |
| 6V-9509 | Face Seal Plug | 1 | |
| 6V-9507 | Face Seal Plug | 1 | |
Note: SERVICE DATA: TOOLING (A) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove filter assembly (4) from fuel priming pump (1).
- Disconnect hose assemblies (2) from fuel priming pump (1).
- Disconnect harness assembly (5) from fuel priming pump (1).
- Remove bolts (3) in order to remove fuel priming pump (1) from the engine.
| |
| Illustration 1 | g00912923 |
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install bolts (3) in order to attach fuel priming pump (1) from the engine.
- Connect harness assembly (5) to fuel priming pump (1).
- Connect hose assemblies (2) to fuel priming pump (1).
- Install filter assembly (4) to fuel priming pump (1).
|
| |
| Illustration 2 | g00912923 |