216 and 232 Skid Steer Loaders 3024 Engine Supplement Alternator - Remove and Install Caterpillar

Removal Procedure

Start By:

1. Disconnect battery cables. Refer to Disassembly and Assembly, "Battery and Battery Cable - Separate and Connect".

Show/hide table



Illustration 1	g00913977

1. Remove bolts (1). Remove cover (2) .

Show/hide table



Illustration 2	g00913978

2. Raise the rubber boot (3). Remove the nut and the wire. Disconnect harness assembly (4) .

Show/hide table



Illustration 3	g00913984

3. Loosen bolt (5). Loosen bolt (8) .

4. Remove belt (6). Remove bolt (5). Remove bolt (8). Remove alternator (7) .

Installation Procedure

Show/hide table



Illustration 4	g00913984

1. Install alternator (7). Install bolt (8). Install bolt (6). Do not tighten bolts.

2. Install belt (7) .

   Note: Refer to the Operation and Maintenance Manual, SEBU7468, "Belt - Inspect/Adjust/Replace" for the correct tightening procedure.

Show/hide table



Illustration 5	g00913978

3. Connect harness assembly (4) .

4. Install the wire and the nut. Lower rubber boot (3) .

Show/hide table



Illustration 6	g00913977

5. Install the cover (2). Install bolts (1). Torque the bolts to 15 ± 3 N·m (11 ± 2 lb ft).

End By: Connect battery cables. Refer to Disassembly and Assembly, "Battery and Battery Cable - Separate and Connect".